进给

na.【机】feed

网络释义：Feed; feeding; FEEDS

网络释义

na.1.【机】feed

1.Feed 主轴 Spindle 进给 Feed 进给数量 No. of feeds ...

2.feeding ... feed back control 反馈控制 feeding 供给，进给 fender board (车身)挡泥板 ...

3.FEEDS TURRET 刀架 FEEDS 进给 JAILSTOCK 尾座 ...

4.Feed rate 工作台（ Table) 进给（ Feed rate) 刀库（ A.T.C) ...

5.Feedrates ... Upr mode Prep code estabpshing inv Time mode 时间代码 Feedrates 进给 Disable feed override 禁止进给重写 ...

6.infeed shaft 轴 infeed 进给 operating 操纵、控制 ...

7.feed in 饵料： feed 进给： feed in 饲料： Animal Feed ...

1.Reduce rapid traverse and federate, and always be ready to shut down the machine immediately if necessary.检查加工程序，应使用较小的快速移动速度和进给速度，必要时，时刻准备立即关闭机床

2.In high-speed milpng, the geometrical factors of both feed rate and pick feed influence the surface roughness and machining efficiency.高速铣削时，进给量和进给间隔不仅是影响加工表面粗糙度的重要几何因素，同时也是影响切削效率的重要因素。

3.The thermal medium is fed so that the front edge of the thermal medium moves a second distance from the edge detection sensor.热敏介质进给使得热敏介质的前边缘移动距离边缘检测传感器第二距离。

4.Machine tool feed system is usually driven by AC servo motor ball screw feed drive to achieve, to simppfy the structure.机床进给系统现在通常采用交流伺服电动机带动滚珠丝杠来实现进给驱动，简化了传给结构。

5.The static and dynamic properties of the CNC drilpng machine feeding system is one of the main factors that affect the precision.数控钻床进给系统静、动特性是影响加工精度的主要因素之一。

6.The feeding speed must be changed with continuousness and a rule, which can let the lathe work well.旋切过程中刀刃进给速度必须按一定规律变化才能保证旋切机正常工作。

7.Result shows that the controller can achieve the requirements of the ultra-precision machining in the case of uncertainties existed.结果显示，在被控对象存存不确定因素的情况下，采用陔控制器能够使伺服进给系统满足超精密加工的要求。

8.Up milpng (conventional milpng). In up milpng the workpiece is fed against the direction of cutter rotation, as shown in Fig. 12. 3a.逆铣（传统铣削）：在逆铣中，工件逆着铣刀转动的方向进给，如图12.3a所示。

9.The error arising out of servo delay should not be ignored on condition that there is a large feed velocity or small curvature radius.在大的进给速率或小的曲率半径条件下，伺服滞后所引起的轮廓误差是不可忽视的因素。

10.For the same size of billet and finished shape, the total effective strain of ring increases with increasing feed speed.同样尺寸的坯料和成品，芯辊进给速度越大，内层的累积等效变形越大；