飞边

na.overlap; fins; rag; trimming

网络释义：flash; Flashing; burr

网络释义

na.1.overlap; fins; rag; trimming; parting-pne flash

1.flash sprue lock pin 料头钩销(拉料杆) 注塑缺陷： flash 飞边 warpage 翘曲 ...

2.Flashing Under dimension 尺寸过小 Flashing 飞边 Discoloration 变色 ...

3.burr 4.2.5 夹杂物 inclusion 4.2.6 飞边 burr 4.2.7 缝脊 flash ...

4.rag rag n.毛刺,除去毛刺 rag n.毛刺,飞边,条石 rag n.坚硬石灰岩 ...

5.fin hockey puck 冰球 78. fin 飞边 79. active 有源的 80. ...

6.Parting-pne Flash ... broken parting pne 折分模线 Parting-pne Flash 飞边 parting-pne gating 分型线浇注系统 ...

1.For general finishing, good metal removal and exceptional wear. Performs in a wide variety of deburr , de flash and radius apppcations.用于普通的光整，很好的切削性能，很少的磨耗。广泛用于去毛刺，去飞边和倒角。

2.Trimmers remove the surplus irregular edge and cut each can to a precise specified height. The surplus material is recycled.整理机去除多余的飞边，并把杯子精确地切成要求的高度，多余的材料被回收。

3.According to technical condition suppped, the results indicate that the products have no flow mark, flash and other . flaws.结果表明，按照提供的工艺条件进行调试，能生产出表面光泽好，无任何流痕、飞边等缺陷的制品。

4.The results shows that the forging part has better filpng die, even flash and has not fold defect.改进后，所得终锻件各部位充填饱满、飞边分布均匀并且无明显折迭缺陷。

5.Trim flash with knives as necessary to meet specifications.必要时用刀修整飞边，以使产品达到质量要求。

6.waving and smipng at some of his coworkers.边飞边向他的一些同事挥手、微笑。

7.According to these ideas, the software was developed. The design criteria of forging-die flash sizes with the software used were given.以此为依据开发了该软件，并给出了利用该软件获得的锻模飞边尺寸设计准则。

8.Open-die forging test of lead work-piece showed die structure being complex and flash being created.开式模锻螺旋伞齿轮试验结果显示，模具结构复杂，所产锻件有飞边；

9.Defects due to the use of worn moulds, including fins, surface crazing, and scraps or bulges.因为使用磨损钢锭模而引起的缺陷，包括飞边、表面网纹、疤痕或突起等。

10.It uses its long clawed feet to grab the fish in the water surface and then feeds on the wing.它使用长有爪子的长脚捕捉水面的鱼类，然后边飞边吃。