锐角

na.acute angle; closed angle

网络释义：sharp corner; sharp angle; right angle

网络释义

na.1.acute angle; closed angle; obtuse angle

1.acute angle account for （数量）占 acute angle 锐角 acute triangle 锐角三角形 ...

2.sharp corner sharp beam 锐光束，窄光束 sharp corner 锐角 filters 尖锐滤光镜 ...

3.sharp angle rule out 排除 sharp angle 锐角 stand by 做好准备，袖手旁观 ...

4.closed angle cpp angle 扣角钢 closed angle 锐角, 尖角 commutation angle 换向重叠角, 安全角 ...

5.right angle angle 直角： right angle 锐角： acute angle 对折： ...

6.Acute angles Integers 整数 Acute angles 锐角 Prime number 质数 ...

7.an obtuse angle5、an acute angle: 锐角（an obtuse angle:钝角）07． acquire基本含义及其用法1、获得；取得She acquired a knowledge of t…

1.Despite the fact that she was balancing on tall, chunky heels, she still had to gaze up at an acute angle to look Diane in the eyes.虽然踩着又高又粗的鞋跟，但要看到黛安娜的眼睛，她还是得仰起头，保持锐角角度。

2.I turned a sharp turn to the westward at the east angle of the road-triangle when I reapzed that the westward trail was all right.当我注意到西行的路可以走的时候，我就在三角形道路的东角转了一个锐角往西行。

3.This produces a sharp corner or a beveled corner , depending on whether the length of the miter exceeds the miter pmit .这将产生一个锐角或切除角，具体取决于斜联接的长度是否超过斜联接限制。

4.Re-sharpen face by same angle which would be kept by single disposable chopstick. Back side should be re-sharpened by more acute angle.再由一支一次性筷子固定住以同样的角度磨表面。磨背面时应保持更加锐角的角度。

5.Check the surface of pipes to avoid burrs and sharp angle, which could spare all damages to wires in the process of installation.检查管道外表面确认无毛刺、锐角，以免在安装时对电缆造成损坏。

6.Open book - Same as a dihedral or inside corner. Two panes of rock join in an acute or obtuse corner that faces left or right.两面角或者内角。两块岩石会聚成锐角或者钝角，向左或者向右。

7.A taper or acute protection tube made from stainless steel is on the front of the products.产品前端配有锥形或锐角不锈钢保护管。

8.Angioplasty of stenosis beyond severely angulated bends (acute angle less than 60? ) can be technically difficult.血管成形术以外严重狭窄弯曲成角（锐角小于60？

9.Obtuse triangle: One of the three angles is an obtuse angle. The other two are acute angles.钝角三角形：有一个角是钝角，有两个角是锐角。

10.To avoid the sharp angles around the inner wall, should punch to sunken arc.为了避免内壁筛孔周边的锐角，冲孔时应冲成下凹的圆弧形。