过电压

na.overvoltage; overtension

网络释义：overpotential; OVP; excess voltage

网络释义

na.1.overtension; overstress; overvoltage; excess voltage; superpotential; overpotential

1.overvoltage inhomogenous field 不均匀场 overvoltage 过电压 insulation coordination 绝缘配合 ...

2.overpotential ... overlay entry 盖板 overpotential 过电压 oxidation 氧化 ...

3.OVP excess voltage preventer 避雷器 excess voltage 过电压 excess 余量 ...

5.superpotential superposition 重叠；叠加 superpotential 过电压 superpower 超功率 ...

6.overtension overtempering 过 (度 )回火 overtension ①过电压②超电压 overthrow distortion 过 …

7.over voltahe under voltage: 欠电压 over voltahe: 过电压 spd fbk loss: 速度反馈丢失 ...

1.The apppance used to pmit transient over voltage and discharge the surging current, it includes one of non-pnear element at least.用于限制瞬时过电压和泄放电涌电流的电器，它至少包含一个非线性的元件。

2.Battery over- voltage sensing allows the IC to stand-off up to 50 V , allowing the chip to meet automotive IC load- dump requirements .电池过电压感测允许IC承受高达50伏特的电压，让芯片可满足汽车IC负载突降要求。

3.and the damping circuit (H) is connected with a circuit positioned between the over voltage protector (MOV) and the breaker (B).阻尼回路连接在过电压保护（MOV）与断路器（B）之间的线路上。

4.Overvoltages may also BE produced by certain types of asymmetrical fault mainly on systems with ungrounded neutrals.在中性点不接地系统中，过电压也可能主要由某些类型的不对称故障所引起。

5.Switching over-voltage has been obtained by simulating locomotive getting into and out of the neutral section.并通过仿真模拟机车进入和离开中性段时所产生的操作过电压；

6.Analysis the cause of producing operating overvoltage of vacuum circuit breaker, a method of restricting operating overvoltage.分析了真空断路器的操作过电压产生原因，探讨了限制操作过电压的方法。

7.The over-voltage and over current of resonance affect the safe operation of the system seriously.谐振时的过电压和过电流，严重影响了系统安全运行。

8.System failure or switch operation caused transitional process overvoltages, which also called switching overvoltages.操作过电压是由系统故障或开关操作等引起的过渡过程过电压。

9.The switch with closing resistor, RC equipment and MOA are used to pmit switching overvoltages. Certain effect is obtained.仿真中运用带合闸电阻的开关、RC阻容装置及其氧化锌避雷器来限制操作过电压，并取得了一定的成效。

10.Measurement Category II connections require protection for high transient over-voltages often associated with local AC mains connections.测量类别II连接要求具有高瞬间过电压保护，这些过电压经常发生在本地交流电源连接上。